POLUX – Non Destructive Wood Pole Inspection

The POLUX system of wood pole inspection is a new non-destructive evaluation (NDE) technology that is being increasingly used worldwide for wood pole inspection and management. POLUX and its analysis software K-Store offer a fast, much more reliable and more cost-effective means of testing and managing a utility’s wood pole fleet.

POLUX is a hand-held portable instrument to test the condition and strength of wood poles, non destructively, in the field. It gives an instantaneous indication (red or green light) whether the pole is safe to climb, and an estimate of the expected remaining service life. It succeeds where other attempts have failed, by measuring both compressive strength and moisture, and correlating the two variables and comparing against parameters developed from measurements under controlled conditions. A handheld computer provides visual data display. (Future plans may include incorporation of GPS.)

POLUX was developed and commercialized in Europe by a Swiss company with funding from Electricite de France. EdF has accredited it for safety and has adopted it as their only acceptable method for wood pole testing. More than 100 instruments are in use in Europe, validating its performance and providing a base of experience. The instrument is manufactured to ISO 9002 standards and the testing procedure has been certified ISO 9001 in Europe.

Pole + Management Inc., in Montreal, is the exclusive licensee in North America for the POLUX technology. The company has done exhaustive testing and calibration (i.e. for the different wood species used in the Americas), and is now beginning to market it. They made their first major public showing at the April IEEE T&D show in New Orleans.

In 1998, Pole + began inspections for a dozen small utilities in Ontario, and also performed wood pole inspections for Ontario Hydro on some of their transmission lines. Hydro-Quebec did tests at their research center IREQ which compared POLUX, sonic, drill, x-ray, and other methods of pole inspection– the POLUX measurements consistently had the highest correlation ( r > 0.85) with the actual residual breaking strength of the pole. (reports available). Other utilities who have also evaluated different methods of measuring pole strength, concluding that sonic testers do not correlate with the pole breaking strength and that a valid instrument must have a correlation of at least r > 0.7.

The strength of a pole is proportional to fiber stress and to the cube of the circumference of the pole. Almost 80% to 90% of the bending capacity in a typical utility pole is developed in the outer 2 to 3 inches of the shell. The center portion of a pole adds very little to its bending strength, so voids or decay there are far less important.

Many US utilities rely on core samples (to detect the presence of decay) and treatment programs, but this can give a false sense of security, and be less cost effective in the long run. (Treating a pole that doesn’t need it can sometimes actually reduce its strength and remaining life!) In some companies, work practices and union rules may hinder adoption of this different approach, but the company (and Europe!) is convinced that it is the better way to go, for many reasons.

Benefits from Reliable Non-Destructive Wood Pole Inspection
– Decisions based on reliable, repeatable, objective data, independent
of operator interpretation
– Capability to decide when to replace, retreat or strengthen poles
– Capability to plan purchasing, storage, and maintenance needs
– Long term trend patterns will provide a sound basis for new, cost-effective
and ecologically sound strategies for pole selection, placement, re-inspection
and maintenance
– Reduce capital and maintenance cost
– Improve system reliability and customer satisfaction.

The company will send on request a CD-ROM that provides the complete story. Also, their website gives a good introduction to the technology and concepts.
http://www.poleplus.com

They are looking for U.S. utilities to participate in small pilot demo programs, where the company will test several hundred poles (at $10 each).

Contact: Edward Ezer, Pole+ Management, Inc. (Montreal, Quebec)
514-947-0122 eezer@poleplus.com

(UFTO has been following these developments since mid 1996.)

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply